Microcom 466 Instrukcja Operatora Pobierz pdf (Strona 41)

Chapter 5 Printer Commands

466 Operators Manual 35

load data or control numbers and are preceded by a ^AXX, where XX represents the data or

control number. Unless otherwise specified, command codes should precede or follow the

actual format layout. They should be placed before the ^D57 or just before the print command

^D3.

Commands not listed in 5.3.1 (the dip switches and non-volatile commands section) are not

retained when the printer is turned off and if desired, must be sent again upon power-up.

When possible, the following commands are grouped by function. See the quick reference

command summary in Appendix B for a listing by number.

Some commands can be substituted with equivalent control-codes. If this is the case, there will

be an equivalence statement in the description.

Example of Command usage:

^A3^D75^D3? (This sequence will print a batch of three labels).

5.3.1 SOFTWARE SWITCHES AND NON-VOLATILE COMMANDS

The following commands are different from the other printer commands in that they are stored

in non-volatile memory and configure the machine upon power-up. Once sent to the printer,

they do not need to be sent again.

The following commands are loaded on power-up. Although they can be set, they will not be

used until the printer has been restarted. The printer will not use these settings until this is

done.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 98 99

Brak uwag

Microcom 466 Instrukcja Operatora Strona 41