Microcom LDSII Instrukcja Użytkownika Pobierz pdf (Strona 67)

Chapter 2 Printer Commands

LDSII Programming Guide - 880015-0123 51

2. Load media into the printer.

3. Establish communication with a terminal emulation program (HyperTerminal, Tera Term

Pro, etc.).

4. Be sure that the printer is in a transmissive detection mode (“2” or “3”) by issuing the

“^D636)?” command.

5. Enter Tic mode [^D900)f,3].

6. The printer will return a numerical value for the Gap Sensor output.

7. A high value should be returned for the area outside of the black line. A low value

should be returned when the black line passes over the black line.

8. Enter a new threshold value (between the high value and the low value) using the Gap

Sensor Threshold command [^D680)n]

Figure 11 ^D900 Die-cut Listing

Label sensed

(Beginning)

Label sensed

(Beginning)

Threshold is “crossover point”

between [label backing] and

[label backing + label].

Threshold will be a value

between upper value and

lower average value.

Gap Threshold Setting – 30

(Factory Setting)

Values being

reported from

the registration

mark sensors

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 120 121

Brak uwag

Microcom LDSII Instrukcja Użytkownika Strona 67